How to Fix a Truck Dent or Scratch

If you’re driving around Montrose and find a new scratch or dent on your pickup, we at Flower Motor Company want you to know how to take care of it. Below, our service team explains how to fix a dent in a truck yourself. But if you’re not the DIY type, make a service appointment with our service center today–we’re here to help!

How To Fix Scratches on a Truck 

When there’s a scratch on your new RAM 1500, and you don’t want to take it to a mechanic or body shop for repair in Ridgway, these are some do-it-yourself tips for fixing scratches on a truck:

• Candle Wax – Gently rub candle wax over the cleaned area on your paint to seal the scratch.
• Super Glue – Like candle wax, this can help seal the scratch temporarily and blends with the truck to hide the damage.
• Paint Polish or Rubbing Compound – You want to start with the least aggressive solution to fix scratches on a truck. You can always do more, but it can’t be reversed if you overdo it. Start with a light polish with a less abrasive foam pad, and work up to higher-grit polish or compound. If the scratches remain on your paint, you should consider wet-sanding.
• Wet Sandpaper – You can typically remove shallow scratches on the surface with wet sandpaper. Clean the area and rub it gently with 2000-grit wet sandpaper. Once the scratch is almost invisible, apply a rubbing compound and finer polish. Next, use a wax or paint sealant for protection. Always wash your truck before doing any scratch removal.
• Touch-Up Paint: Usually, touch-up paint is available at service centers like the one at Flower Motor Company near Delta. It helps hide deeper scratches and you can order it online.

How to Fix a Dent in a Truck

If you want to know how to fix a small dent in a truck so it doesn’t ruin the curb appeal, you’re in luck! Try one of the simple tips below to fix a dent in a truck:

• Plunger – Use a bathroom plunger or a car dent plunger to pop the dent out gently,
• Hammer or Mallet – Use a hammer or mallet on the opposite side of the dent to lightly tap the spot back into place. Use the hammer for more minor dents and a mallet for larger ones. Be careful to protect the side you hammer on with a towel to soften the blow and avoid more damage.
• Dent Puller – This is an advanced procedure and requires more skill. Drill a hole in the dent, lace the wire through the hole, and pull the dent back to surface level. You’ll then need to fill, sand, and paint the hole.

For Bigger Fixes, Trust the Team at Flower Motor Company

Now that you know how to fix a dent in a truck, if the damage is too much for a hammer or your skill level, it’s time to turn to the Flower Motor Company service center. Not only will our technicians know how to fix the damage best, but they’ll handle your truck carefully and quickly get you back on Telluride streets. Check our service specials and contact us today!